Touch Dim 1A Dimmer

The body is made of durable ABS plastic

Power supply connection is carried out in two alternative ways: terminal connection or power connector.

Equipment:

Receiver-dimmer, radio remote control (5 buttons + touch ring).

Remote control power supply: 2 AAA batteries (not included).

Control:

Button 1 ON – on.

Button 2 OFF – switch off.

Button 3 – Maximum brightness level.

Button 4 – Medium brightness level.

Button 5 – Minimum brightness level.

Touch ring for precise, smooth brightness selection (50 levels).

*When the power is turned off and on, the previous mode is restored.

ATTENTION: You may initially need to configure the remote control to the receiver. To do this, immediately after connecting power to the receiver, press and hold button 3 for 3 seconds. The light source connected to the receiver (e.g., an LED strip) should flash three times, indicating that the connection between the receiver and the remote control has been established.

To delete the established connection between the receiver and the remote control, after connecting power to the receiver, press button 3 on the remote control five times in a row for 3 seconds. After this, the light device connected to the receiver should make 6 light flashes - this means the connection between the receiver and the remote control has been deleted.

!!!Caution!!! Do not touch the touch ring while replacing the batteries to avoid deteriorating the sensor's performance. Wait at least 3 seconds after installing the batteries before using the remote control. If the touch ring loses sensitivity, remove and reinsert the batteries.

Application:

Used to control LED strips, modules, linear arrays, and spotlights. Powered by 12-24VDC power supplies, the signal is amplified using a signal amplifier. Controlled by remote control.

Download instructions...