LED strip FLT 81-T

LED strip FLT 81-T

Technical specifications

Luminous flux:

Colors :

Available in: neutral white FLT 81NW-T, warm FLT 81WW-T, ultra-warm FLT 81UWW-T.
Available to order: Daylight White FLT 81DW-T

Specific features of FLT 81- T :

Flexible printed circuit board (tape) with self-adhesive backing.

The strip can be cut into segments (the cutting line is marked on the LED strip) without affecting their functionality. Each segment can be used separately.

IP67 moisture protection is provided by a transparent continuous silicone coating.

Feature: heat-resistant LEDs.

It is also possible to adjust the brightness of the light using a dimmer.

Application of LED strip FLT 81- T :

The FLT 81-T LED strip from TM”Verso” is designed for installation in rooms with high humidity and temperature.

The main purpose is Saunas, Baths, Hammams, Roman steam rooms .

It's important to ensure the ends of the LED strip are sealed if you're not using a solid 5-meter factory length. Before installation, ensure the protective sheath is intact.

The second important condition is to not allow the temperature to exceed the permissible level of 100°C in the place where the LED strip is installed.

This generally means that the FLT 81-T LED strip can be installed:

- in a sauna or steam room, under the bench and behind the backrest. It is important not to place the tape near or above the heater/stove, as the surface temperature there may exceed 100°C.

- in the hammam and Roman steam room under the bench and on the ceiling in the cornices, with the dome illuminated.

For long-term use (commercial baths), to extend the service life, reduce the rate of degradation of LEDs and loss of brightness, it is recommended to use this LED strip at temperatures up to 85°C.

Mounting/attaching heat-resistant LED strips to the surface is done in two ways:
1. Installation using CC78 silicone clips. This is most convenient for wooden surfaces, using stainless steel screws inserted through the holes in the sides of the clips.
2. Installation with silicone adhesive/sealant. This is most convenient on surfaces such as tiles or mosaics. However, you will need to secure the tape during installation until the adhesive/sealant has completely cured.
Caution: Do not use adhesives containing solvents, acetones...this may damage the silicone shell of the LED strip.
Do not heat the LED strip during installation using a hair dryer, etc. This may damage the casing and cause the LEDs to fail.

The expected service life of the LED strip is up to 20,000 hours.

24-month warranty (subject to temperature conditions (no more than 100°C)