LED strip FLT 80RGB-T12-C7

LED strip FLT 80RGB-T12-C7

Technical specifications

Luminous flux:

Colors :

RGB

FLT 80 RGB -T12- C7 specifics :

The strip can be cut into segments (cut line is marked on the LED strip) without losing their functionality. Each segment can be used separately.

Waterproofing is provided by a transparent braid. When cutting, high-quality waterproofing is required.

It is recommended to use this tape in the bathroom and other rooms with high humidity.

It is also possible to adjust the color and brightness of the glow using the RGB controller.

Application of LED strip FLT 80 RGB -T12- C7 :

LED strip FLT80RGB-T12-C7 from TM”Verso” is designed for installation in rooms with high humidity and temperature.

The main purpose is Saunas, Baths, Hammams, Roman steam rooms .

It is important to ensure the tightness of the ends of the LED strip if a non-solid 5-meter factory section is used. Before installation, make sure the protective braid is intact.

The second important condition is to not allow the permissible temperature level of 100°C to be exceeded at the place where the LED strip is installed.

Typically this means that the FLT80RGB-T12-C7 LED strip can be installed:

- in a sauna and bathhouse under the bench and behind the back of the bench. It is important not to place the tape in the area of the heater/stove and above it, since the surface temperature there may be higher than 100°C.

- in the hammam and Roman steam room under the bench and on the ceiling in the cornices, with the dome illuminated.

For long-term use (commercial baths), to extend the service life, reduce the rate of degradation of LEDs and loss of brightness, it is recommended to use this LED strip at temperatures up to 85°C.

Mounting/attaching to the surface of a heat-resistant, LED strip is done in two ways:
1.    Installation on silicone fasteners-clips CC78. Most conveniently on wooden surfaces by screwing stainless steel self-tapping screws through the holes in the sides of the mounts.
2.    Installation on silicone adhesive sealant. It is most convenient to do this on surfaces such as tiles, mosaics. But it will be necessary to fix the tape in the process of installation until the glue-sealant completely hardens. 
Attention: Do not use adhesives containing solvents, acetones...it can damage the silicone shell of the LED strip.
Do not heat the LED strip during the installation process with a construction hair dryer, etc. This can both damage the shell and destroy the LEDs.
 

The expected service life of the LED strip is up to 20,000 hours.

24 months warranty (subject to temperature conditions (no more than 100°C))