Touch RGB Controller 2

The body is made of durable ABS plastic

Power supply connection is carried out in two alternative ways: terminal connection or power connector.

Equipment:

RGB controller, radio remote control (5 buttons + touch ring).

Remote control power supply: 2 AAA batteries (not included).

Control:

Button 1 ON/OFF – on/off.

Button 2 Mode – switches between 15 modes

Button 3 White – Select white/exit to color selection mode.

Button 4 Brightness Up / Speed UP - decrease brightness / decrease speed in dynamic modes

Button 5 - Brightness DOWN / Speed DOWN - increases brightness / increases speed in dynamic modes

Modes:

1. Automatic change of all colors;

2. Three colors change in leaps;

3. Seven colors change in leaps;

4. Three colors change smoothly;

5. Seven colors change smoothly;

6. Red color flashing;

7. Blue color flashes;

8. Purple color flashing;

9. Green color flashes;

10. Yellow color flashing;

11. Cyan blinks;

12. White color flashing;

13. Change of red and blue colors;

14. Change of green and blue colors;

15. Change of red and green colors.

In modes 1-12, buttons 4 and 5 control brightness; in modes 13-15, buttons 4 and 5 control the color change speed.

!!!Caution!!! Do not touch the touch ring while replacing the batteries to avoid deteriorating the sensor's performance. Wait at least 3 seconds after installing the batteries before using the remote control. If the touch ring loses sensitivity, remove and reinsert the batteries.

Application:

Used to control RGB LED strips, modules, linear arrays, and spotlights. Powered by 12-24VDC power supplies, the signal is amplified using an RGB signal amplifier. Controlled by remote control.

Related products: Remote control mount.

Download instructions...