LED strip FLT 80UWW-T-C7

Technical specifications

LED type SMD 2835

Number of LEDs per meter 140 LED/m

Power supply 24V DC

Current, A/m A/m 0.4

Consumption W/m W/m 9.6

Radiation angle 120

Reel, m 5m

Size, mm 12 x 4 mm

Cutting capacity 50mm (7 LEDs)

Dust and moisture protection level, IP IP67

Color rendering index CRI CRI 80RA

Luminous flux:

Warm white, (2700K) 950 lm/m

Storage temperature -40º- +100ºС

Operating temperature -25º- +100ºС

FLT 80UWW-T-C7 specifics:

The strip can be cut into segments (cutting line is marked on the LED strip)

without losing their functionality. Each segment can be used separately.

Moisture insulation is provided by a transparent rectangular silicone tube.

When cutting, high-quality waterproofing is required.

It is also possible to adjust the brightness of the light using a dimmer.

Application of LED strip FLT 80UWW-T-C7:

LED strip FLT 80UWW-T-C7 from TM”Verso” is designed for installation in

rooms with high humidity and temperature.

The main purpose is Saunas, Baths, Hammams, Roman steam rooms.

It is important to ensure that the ends of the LED strip are sealed if other than the one used

one-piece factory section of 5 meters. Before installation, make sure the protective layer is intact.

braids.

The second important condition is not to allow the temperature to exceed the permissible level

100°C at the place where the LED strip is installed.

This generally means that the FLT 80UWW-T-C7 LED strip can be installed:

- in a sauna and bathhouse under the bench and behind the back of the bench. It is important not to place the tape in the area

sauna stoves/ovens and above them, since the surface temperature there can be higher than 100°C.

- in the hammam and Roman steam room under the bench and on the ceiling in the cornices, with the dome illuminated.

For long-term use (commercial baths) to extend the service life,

It is recommended to reduce the rate of degradation of LEDs and loss of brightness

use of this LED strip at temperatures up to 85°C.

Mounting/attaching to the surface of a heat-resistant, LED strip is done in two ways:
1.    Installation on silicone fasteners-clips CC78. Most conveniently on wooden surfaces by screwing stainless steel self-tapping screws through the holes in the sides of the mounts.
2.    Installation on silicone adhesive sealant. It is most convenient to do this on surfaces such as tiles, mosaics. But it will be necessary to fix the tape in the process of installation until the glue-sealant completely hardens. 
Attention: Do not use adhesives containing solvents, acetones...it can damage the silicone shell of the LED strip.
Do not heat the LED strip during the installation process with a construction hair dryer, etc. This can both damage the shell and destroy the LEDs.

The expected service life of the LED strip is up to 20,000 hours.

24 months warranty on solid sections of our production (subject to compliance

temperature conditions (no more than 100°C)