5-in-1 TOUCH Matter-F5-Res Receiver-Controller

Enables switching on/off and brightness control of light sources (LED strips, modules, lines).

The Touch Matter-F5-Res receiver-controller is compatible with all TM”Verso” Touch series remote controls.

Controlled via Wi-Fi network by mobile applications:

Tuya smart, Apple Home Kit, Amazon Alexa、Google Home、SmartThings.

(Does not support 5G routers)

Touch Matter-F5-Res (5-in-1) can work with single-color strips and two-color strips (for example, with adjustable white color temperature). It also supports RGB, RGBW, and MC (RGBW+WW). Modes are switched using the SET button on the receiver body.

Technical characteristics:

The body is made of durable polycarbonate.

- Control directly from your mobile phone via applications.

- Compatible with Amazon Alexa and Google Assistant, Siri.

- Compatible with many Touch series remote controls (both dimmers and RGB/MC).

- Possibility of changing the PWM frequency (6KHz/400Hz)

- retransmission and synchronization of the remote control signal - this is necessary when receivers are located over a large area or space (facades, streets, long corridors, large halls and rooms...)

- Disturb mode (preset): If the light is off after a power outage and then restoration, the light will not turn on. However, it will turn on again when the power is lost and restored.

* Pairing with the remote control (Link) is carried out according to the following algorithm:

1. a) Turn off the power for more than 10 seconds, and then turn on the power.

Or b) briefly press the SET button on the receiver body.

2. Press the power button of the corresponding channel on the remote control 3 times briefly within 3 seconds.

3. To confirm pairing, the LED strip connected to the receiver should light up smoothly 3 times, this means successful pairing.

** Unlinking the remote control is carried out according to the following algorithm:

1. a) Turn off the power for more than 10 seconds, and then turn on the power.

Or b) briefly press the SET button on the receiver body.

2. Press the power button of the corresponding channel on the remote control 5 times briefly within 3 seconds.

3. To confirm unbinding, the LED strip connected to the receiver should light up briefly 10 times, this means successful unbinding.

The receiver's output mode is selected by briefly pressing the Mode button on the housing. A light indicator will indicate the current mode:

- 1-CH - Monochrome tape mode.

- 2-CH - Two-color hybrid tape mode (CCT).

- 3-CH – RGB.

-4-СH – RGBW.

-5-СH - MC(RGBW+WW).