Receiver-dimmer TOUCH DIM 9FM-RES

Enables switching on/off and brightness control of light sources (LED strips, modules, lines).

The Touch Dim 9FM-Res receiver-controller is compatible with all TM”Verso” Touch series remote controls.

Controlled directly by a mobile phone via the Tuya smart app (via WiFi), as well as by Touch series remote controls and the Touch WiFi-2 Controller (using a smartphone). (Does not support 5G routers)

An important advantage is the ability to connect fairly high loads: up to 10 Amps per channel and up to 20 Amps in total.

The TOUCH DIM 9FM-RES (2-in-1) can work with single-color strips or two-color strips (for example, with the ability to adjust the white color temperature). Modes are switched using the SET button on the receiver body.

The body is made of durable polycarbonate.

- Control directly from your mobile phone via the Tuya smart app.

- Compatible with Amazon Alexa and Google Assistant.

- Compatible with many Touch series remote controls.

- Possibility of changing the PWM frequency (6KHz/400Hz)

- signal retransmission and synchronization - this is necessary when receivers are located over a large area or space (facades, streets, long corridors, large halls and rooms...)

- Possibility of wired connection of a switch (like a bell). For control: on/off with a short press, brightness adjustment with a long press.

- Disturb mode (preset): If the light is off after a power outage and then restoration, the light will not turn on. However, it will turn on again when the power is lost and restored.

* Pairing with the remote control (Link) is carried out according to the following algorithm:

1. a) Turn off the power for more than 10 seconds, and then turn on the power.

Or b) briefly press the SET button on the receiver body.

2. Press the power button of the corresponding channel on the remote control 3 times briefly within 3 seconds.

3. To confirm pairing, the LED strip connected to the receiver should light up smoothly 3 times, this means successful pairing.

** Unlinking the remote control is carried out according to the following algorithm:

1. a) Turn off the power for more than 10 seconds, and then turn on the power.

Or b) briefly press the SET button on the receiver body.

2. Press the power button of the corresponding channel on the remote control 5 times briefly within 3 seconds.

3. To confirm unbinding, the LED strip connected to the receiver should light up briefly 10 times, this means successful unbinding.

The output signal mode on the receiver is selected using the SET button on the body:

- Long press – enters the edit mode. Then, within 3 seconds, select the desired output mode with short presses. The mode is identified by the color of the indicator LED on the receiver body.

- Monochrome tape mode – the indicator is red.

- Two-color hybrid tape mode - green indicator