Receiver-controller Touch MC 4FR-Res

The Touch MC 4FR-Res (5 in 1) receiver-controller is compatible with the Touch series remote controls from TM”VERSO”, including dimmer remote controls for single and dual-color solutions.

The main difference of this receiver-controller is its versatility (5 in 1), it can be used to control both RGB LED strip, and RGBW or Multicolor (5 colors), as well as Monochrome and Two-color CCT (usually warm white + cold white). The desired mode is selected during installation using the button on the body, identified by the color of the LED glow on the receiver body.

The second advantage is the ability to connect fairly high loads: up to 15 Amps per channel and up to 30 Amps in total.

- The body is made of durable plastic
- Signal retransmission and synchronization function
- Power connection via terminals.

- PUSH function is available - wired control using the TOUCH-PS1 bell type button.

Application:
Used to control LED strips, modules, lines, spotlights. Powered by 12-24VDC power supplies, signal amplification using the AM-6, AM-7, AM-8, Amd-3 signal amplifier.

Advantages of the Touch MC 4FR -res model:

- Compact dimensions
- versatility - works with a wide range of Touch series remote controls from TM VERSO.
- Possibility of changing the PWM frequency (16KHz/250Hz)
- Possibility to choose a set of programs (two sets of 9 programs)
- retransmission and synchronization of the signal - this is necessary in cases where receivers are located over a large area or length (facades, streets, long corridors, large halls and rooms...)

- disturb mode (preset): in case of the glow being off when the power supply is lost and restored, the light will not turn on. (But it will turn on when the power supply is lost and restored again.)

* Pairing with the remote control (Link) is carried out according to the following algorithm:

1. a) Turn off the power for more than 10 seconds, and then turn on the power.

Or b) briefly press the SET button on the receiver body.

2. Press the power button of the corresponding channel on the remote control 3 times briefly within 3 seconds.

3. To confirm pairing, the LED strip connected to the receiver should light up smoothly 3 times, this means successful pairing.

** Unlinking the remote control is carried out according to the following algorithm:

1. a) Turn off the power for more than 10 seconds, and then turn on the power.

Or b) briefly press the SET button on the receiver body.

2. Press the power button of the corresponding channel on the remote control 5 times briefly within 3 seconds.

3. To confirm unbinding, the LED strip connected to the receiver should light up briefly 10 times, this means successful unbinding.

- Selectable mode from 1 to 5 control channels. For mono-color, bi-color, RGB, RGBW and Multi-color MC (RGB+CCT) LED strip.

The selection of one of five output signal modes on the receiver is carried out using the SET button on the body:

- long press – enter the change mode. Then within 3 seconds you need to select the desired output mode with short presses, the mode is identified by the color of the indicator diode on the receiver body.

- Single color mode – the indicator is white.

- Two-color mode (TCM) – the indicator is yellow.

- RGB strip mode – the indicator is red.

- RGBW strip mode – green indicator.

- Multicolor(MC) tape mode – blue indicator.

- Selectable mode from 1 to 5 control channels. For mono-color, bi-color, RGB, RGBW and Multi-color MC (RGB+CCT) LED strip.