Wall-mounted remote control Touch WDim (P)

For controlling receivers – dimmers Touch Dim-4D-Res ; Touch Dim-4D U -Res

Functionally duplicates the Touch Dim-4(P) remote control for one receiver or group.

*When the power is turned off, the previous mode is restored.

An unlimited number of receiver-controllers and signal receiver lamps can be installed on each channel of the remote control.

The signal receiver-controller can be controlled simultaneously by up to four remote controls.

Control:

On - switching on.

Off - short press - turn off, long press - night mode 5% brightness.

Brightness scale - brightness adjustment from 1% to 100%.

ATTENTION: You may initially need to configure the remote control to the receiver. To do this, immediately (within 2 seconds) after connecting power to the receiver, press the ON sensor 3 times within 3 seconds. The light should flash smoothly three times, indicating that the connection between the receiver and the remote control has been established. If this does not happen, unplug the light and repeat the process after 10 seconds.

To delete the established connection between the receiver and the remote control, you must immediately (within 3 seconds) after connecting power to the receiver, press the ON sensor five times in a row within 3 seconds. After this, the lamp should make 10 light flashes - this means the connection between the receiver and the remote control has been deleted.

*When installing batteries (and for 3 seconds afterward), do not touch the sensors. Otherwise, poor sensitivity will occur. In this case, reinstall the batteries.

Application:

Used to control decorative and functional interior lighting.

Equipment:
Dimmer, instructions.