Touch RGBW 3 Controller

The body is made of durable ABS plastic

Power supply connection is carried out in two alternative ways: terminal connection or power connector.

Equipment:

RGB controller, radio remote control (5 buttons + touch ring).

Remote control power supply: 2 AAA batteries (not included).

Instructions:

Control:

1. ON – switching on.

2. OFF – switch off.

3. Color touch circle – for selecting static glow colors.

4. Light indicator of touch sensors.

5. Increase the speed of color change/flickering/blinking.

6. Increasing the brightness of the glow.

7. Reduce the brightness of the glow.

8. Reduce the speed of color change/flickering/blinking.

*When the power is turned off, the previous mode is restored.

ATTENTION: You may initially need to configure the remote control to the receiver. To do this, immediately after connecting power to the receiver, press and hold sensor 5 for 3 seconds. The light source connected to the receiver (e.g., an LED strip) should flash three times, indicating that the connection between the receiver and the remote control has been established.

To delete the established connection between the receiver and the remote control, after connecting power to the receiver, press sensor 5 on the remote control five times in a row. After this, the light device connected to the receiver should flash 9 times - this means the connection between the receiver and the remote control has been deleted.

The remote control can control an unlimited number of signal receivers.

The signal receiver can be controlled simultaneously by up to four remote controls.

Modes:

1. White color is constantly on; (Only white(W) channel)

2. White color + choice of touch ring color;

3. All colors change smoothly; (the white channel does not work)

4. Four colors change smoothly (green, blue, red, white);

5. Four colors change in leaps;

6. Seven colors change in leaps (including white);

7. Changing red and white colors in leaps;

8. Changing blue and white colors in leaps;

9. Changing green and white colors in leaps;

10. Red color flashing;

11. Blue color flashes;

12. Green color flashes;

In all modes, you can change the brightness of the glow and the speed of flickering/color change.

!!!Caution!!! Do not touch the touch ring while replacing the batteries to avoid deteriorating the sensor's performance. Wait at least 3 seconds after installing the batteries before using the remote control. If the touch ring loses sensitivity, remove and reinsert the batteries.

Do not short-circuit the contacts on the signal receiver - this may damage it.

Do not use the remote control in areas with high electrostatic voltage, as this may damage it.

Application:

Used to control RGBW LED strips, modules, linear arrays, spotlights, and RGB LED products. Powered by 12-24VDC power supplies, the signal is amplified using an RGBW signal amplifier. Controlled by remote control.