Touch RGB 3 Controller

Equipment:

RGB controller, radio remote control (5 buttons + touch ring).

Remote control power supply: 2 AAA batteries (not included).

Control:

1. ON – switching on.

2. OFF – switch off.

3. Color touch circle – for selecting static glow colors.

4. Light indicator of touch sensors.

5. Increase the speed of color change/flickering/blinking.

6. Increasing the brightness of the glow.

7. Reduce the brightness of the glow.

8. Reduce the speed of color change/flickering/blinking.

*When the power is turned off, the previous mode is restored.

ATTENTION: You may initially need to configure the remote control to the receiver. To do this, immediately after connecting power to the receiver, press and hold sensor 5 for 3 seconds. The light source connected to the receiver (e.g., an LED strip) should flash three times, indicating that the connection between the receiver and the remote control has been established.

To delete the established connection between the receiver and the remote control, after connecting power to the receiver, press sensor 5 on the remote control five times in a row. After this, the light device connected to the receiver should flash 9 times - this means the connection between the receiver and the remote control has been deleted.

The remote control can control an unlimited number of signal receivers.

The signal receiver can be controlled simultaneously by up to four remote controls.

Modes:

1. White color is constantly glowing;

2. White color flashes smoothly;

3. All colors change smoothly;

4. Three colors change smoothly (green, blue, red);

5. Seven colors change in leaps;

6. Three colors change smoothly;

7. Changing red and green colors in leaps;

8. Changing red and blue colors in leaps;

9. Changing green and blue colors in jumps;

10. White color flashing;

11. White color shimmers;

12. Red color flashing;

13. Red color flickers;

14. Green color flashes;

15. Green color flickers;

16. Blue color flashing;

17. Blue color flickers;

18. Yellow color flashing;

19. Yellow color flickers;

20. All modes are changed sequentially in a circle.

In all modes, you can change the brightness of the glow and the speed of flickering/color change.

!!!Caution!!! Do not touch the touch ring while replacing the batteries to avoid deteriorating the sensor's performance. Wait at least 3 seconds after installing the batteries before using the remote control. If the touch ring loses sensitivity, remove and reinsert the batteries.

Do not short-circuit the contacts on the signal receiver - this may damage it.

Do not use the remote control in areas with high electrostatic voltage, as this may damage it.

Application:

Used to control RGB LED strips, modules, linear arrays, and spotlights. Powered by 12-24VDC power supplies, the signal is amplified using an RGB signal amplifier. Controlled by remote control.