Touch SPI-R3 SPI LED Strip Control Receiver

Touch SPI-R3 SPI LED Strip Control Receiver

The receiver-controller is designed to control SPI LED strips, for example Smart LED strip FMT 12RGB(IC) from TM "VERSO".

The Touch SPI-R3 receiver supports products on control chips:

TM1809, TM1804, TM1812, SK6813, UCS1903, UCS1909, UCS1912, UCS2903, UCS2909, UCS2912, WS2811, WS2812, WS2813, WS2815，SK6812(RGBW), WS2813(RGBW), WS2814(RGBW)

The Touch SPI-R3 receiver-controller is controlled using the Touch-SPI6 remote control, and minimal control functions are also performed using the Touch-PS1/2/3 Push-button.

Support for SPI LED strips of single color (usually white), RGB, RGBW. Switching to the desired type of strip is done by short pressing of the SET button on the receiver body.

Technical specifications

^* Power supply for the strip over 10A is provided directly by power supplies, but not through the controller.

Control options with Touch-SPI6 remote control :

1. Selectable color for both static and dynamic glow modes.
2. Selection of the number of pixels (pixel = part of the LED strip with one microchip. For the FMT 12RGB(IC) strip it is 5 cm, 3 LEDs) for control. For single-color (2048), RGB (1536), RGBW (1024).
3. Selecting the speed of dynamic programs.
4. Selecting the brightness of the glow
5. Selection of dynamic programs (20 programs)
6. Selecting the direction of dynamics.
7. Save one mode for one-button recall.
8. Unique ability to customize color, brightness and dynamic on/off speed of LED strip.
9. Works in parallel with the Push button connected to the receiver.

Control options using the Push -button Touch- PS 1/2/3:

The button is connected to the receiver's Push terminals. Connection is possible using the Touch P1-3 or Touch P2-3 Push dimmer transmitter.

- A short press of the button turns on/off. At the same time, the color, brightness and speed of dynamic on/off can be pre-set using the Touch-SPI6 remote control (turning on occurs sequentially from one end to the other, and turning off in the opposite direction).

- Long press of the button:

1. Switching dynamic modes (20 programs) - when connecting directly with wires of the button and receiver. And then after short presses, dynamic switching on will occur with subsequent automatic launch of the last dynamic program.

2. Brightness control - when connected via a Touch P1-3 or Touch P2-3 Push-dimmer transmitter. - and this is very important if you intend to use it only as lighting with dynamic on/off.

** It is possible to connect a remote PIR sensor PIR-S1, but with it, switching on occurs without a dynamic effect.

To pair with the remote control you need:

Option 1. Press the SET button on the receiver – then press (within 3 seconds) the ON button on the remote control 3 times.

Option 2. Turn off the power of the receiver, then connect it - then press (within 3 seconds after connecting) 3 times the ON button on the remote control.

As confirmation, the connected LED strip will flash green.

**Unlinking the remote control – the same steps, but press the remote control 5 times. As confirmation, the connected LED strip will flash red.

The functional controller and user-friendly interface of the remote control make it possible to easily set up very bright and dynamic effects without complex equipment and special skills.

Applicable in outdoor advertising, decoration of night clubs, cafes, holiday illumination, home lighting.

Equipment:

- Receiver-controller.

Instruction Touch SPI6 - SPI-R3