PUSH-remote control of dimmer Touch-P1-3

PUSH-remote control of dimmer Touch-P1-3

Designed for connection to the Touch PS1 / 2 / 3 dimmer button. Provides remote control of all Touch series receivers. Possibility of connecting 1 to 3 lighting zones.

- Simple functionality on the dimmer button: turn on/off with a short press, adjust brightness with a long press.

- Usually mounted in a regular wall box, under the control button.

- Requires AC100-240V power supply.

- Dimming range 0.1-100%, 4096 levels

Control on the dimmer button:

- Switch on/off - by short pressing of the button.

- Brightness adjustment – long press the button.

ATTENTION: Initially, it may be necessary to configure the remote control to the receiver. To do this, immediately (within 3 seconds) after connecting the power to the receiver (or pressing the SET button of the receiver ), press the dimmer button of the corresponding channel (light control zone) 6 times within 3 seconds. The lamp should make three smooth flashes, this means that the connection between the receiver and the remote control is established. If this does not happen, then turn off the power to the lamp and repeat the procedure after 10 seconds.

To delete the established connection between the receiver and the remote controls, you must immediately (within 3 seconds) after connecting power to the receiver, press the SET button on the PUSH remote control 5 times in a row within 3 seconds, after which the lamp should make 10 light flashes - this means the connection between the receiver and the remote control has been deleted.

*To connect Triac Dim 2 - read the Triac Dim 2 manual